That’s the exact guide I’m currently working my way through 👍

Just enable it in the BIOS, then make sure the network card has it enabled in Device Manager, and it works like magic (packets).

I’ve been doing it since before the Steam Deck came out, and I just enabled WoL, so the computer sleeps until I open Moonlight and try to access it, then it wakes up. Same with local LLM processing.

Yeah, I unfortunately noticed that I didn’t get the CHT high flow nozzle, just the regular brass one. With my tests and high temps, I was only able to get right around 30mm/s³, so I need to order the high flow nozzle, which they advertise being able to get up to 50mm/s³.

I suffered 3 long years endlessly upgrading, tweaking, and maintaining an Ender 3, so I definitely know your pain! 😂

Yep, you’re exactly right! I forgot that I have the volumetric speed capped at 25 for the Turbo PLA (based that off of random reported values other people used, but didn’t think to try and benchmark it yet). So I’m gonna do that right now! The Overture Matte PLA also prints incredibly cleanly at 300mm/s, so I’m going to benchmark it and the Turbo PLA to see how high this hotend can go. I’ll report back when finished.

I just realized that I have that capped, and I’m now running some flow rate tests on my different filaments. I’ll make another post with the highest flowrate I achieve 👍

Heh - I currently have everything set up for the glass bed mod, except I just read that it doesn’t work with the CR touch sensor, so I’ll need to get a BT Eddy sensor or sonar something. I’ll also need to print a new gantry, and I’ve already tried one that didn’t work as well as the stock one, so just waiting to do more research on that, and then I’ll have my glass bed all set up!

Edit: oh yeah! So the way I calibrated it was:

• I removed the extruder from the gantry (3 screws)
• I fed in some filament (cold, obv) until I could see it on the bottom of the extruder
• Flush cut the filament
• Issue some commands to extrude 100mm
• Flush cut that segment off again (try to cut exactly the same as before)
• Use digital calipers to measure that piece
• then just calculate your new value and run the test again to see if it extrudes exactly 100mm
• enjoy amazing prints

Radiohead?

Or JetKVM 🤗

What does “woke crowd” mean?

My manager at my last job would occasionally ask if anything would make my job better. I would always say “a 4-day work week,” citing weeks where I had taken Friday off as an example of how much more productive I was.

She would always respond by laughing and saying, “not gonna happen. Anything else?”

🖕

Photos are all so close up I hardly saw any bikes.